UEFA Champions League live streaming free

How to install the engine guard (how to install the engine guard,UEFA Champions League live streaming free comprehensive guide) The engine guard is an important protective part to protect the engine. It can ensure that the engine is not broken by rain, snow and road stones, etc. The damage of stone can also effectively reduce wind resistance and improve the driving safety of cars. So, how to install the engine guard? This article will provide you with a comprehensive guide. Preparation First of all, before installing the engine guard, you need to prepare some tools and materials: 1. Engine guard 2. Screwdriver, wrench, pliers 3. Install screws, washers, nuts, etc. 4. Tape, rivets and mounting brackets Step 1: Lift the vehicle Before starting to install the engine guard, we need to raise the vehicle to facilitate us to enter the fixed area of the engine guard.First, use a jack to lift the vehicle, and then use a support frame to fix the vehicle in position to ensure safe lifting. Step 2: Adjust the engine guard to the correct position. Put the brackets and legs of the engine guard on the engine bottom in the correct position, and adjust the direction of the engine guard. Make sure that all holes are aligned with the corresponding holes of the vehicle chassis, so that you can open their mouths and install them appropriately in the chassis area. Step 3: Install the screws and support beam to put the support beam back in the correct position and connect the screws under the engine guard. Then, after adding washers between the chassis area and the engine guard, use a nut to fix them. Make sure that the screws are not too tight or too loose to ensure stability. Step 4: Fixed defenseThe guard plate installs the protective plate inside the engine guard plate, and then fixes it with tape in the lower area of the engine guard plate in the indicated direction. This is to ensure that the protective plate does not sag or move during driving, so as to protect the engine from vibration and wear. Step 5: After installing all the screws at the bottom of the vehicle, hang the rivets at once on each bracket position of the engine guard, fix it with pliers or similar tools, and then tighten them one by one with a wrench. Step 6: Lower the vehicle and check. Now, when you have completed all the steps and connected the connector correctly, you can put down the vehicle and check your work, make sure that the engine guard is fixed in the correct position, and use all recommended screws and rivets to fix it. The last instruction is that it is not difficult to install the engine guard. You just need to follow the above steps.However, during the installation process, we should pay special attention to the selection and quality of materials to ensure the stability and safety of the vehicle in daily use. In addition, it is best to check your engine guard every year and replace it if necessary. In a word, when you need to replace the car engine guard, the above steps can help you install it better and more conveniently. Follow the above steps and pay attention to the details, which can ultimately ensure that your work is correct. If you encounter installation problems or don't understand certain steps, you'd better seek the help of professional technicians.

Contact Us
Phone：020-83484685